Made from strong and light 5052 aluminum to hold your tag firm and up out of the way for maximum tire clearance, prefect for your new dual sport bike. It uses the original tag light and blinkers with out any modifications to your bike. Mounting hardware and instructions included.

---

AS OF 2012 WE NO LONGER MAKE THE HONDA OR YAMAHA BRACKETS! We do have available the universal bracket from PRO MOTO BILLET***** Machined from 6061 Aluminum, this license plate holder is stronger, lighter and easier to install than any others you've seen. Because it's machined and not stamped, it has a much higher tolerance to vibration failure like you've seen with some others out there. In addition, it simply mounts to the existing hardware on you bike(except CRF-X models)making it easy to install and remove. Because it matches the contour of your stock WR or XR rear fender, the plate also stays out of the way of your leg when mounting, dismounting, or struggling up some difficult terrain. It also is strong enough to survive the occasional "loop out", that normally rips most other plate holders from their attachment point. Of course it's not indestructible but it's probably the best setup you'll find to date. XR and WR mounts to the existing 3 bolts that hold your tail light on. CRF-X mounts by drilling 3 holes in the rear fender.******* AS OF 2012 WE NO LONGER MAKE THE HONDA OR YAMAHA BRACKETS! We do have available the universal bracket from PRO MOTO BILLET*****