Shown here is the Mount-Kit-Only for the 1190 and 1290 Adventure and Adventure R. This kit includes the Rubber SUB mount assembly, upper and lower frame bracket, Tower Bridge with tower pin and all necessary hardware to make the installation easy. Also included but not shown, is the special plus 8mm stepped link arm, link arm puller to remove existing arm from your damper and additional soft compound urethane bushings. This is a serious improvement to this model and utilizes the stock triple clamp. This particular kit raises the bars 38mm and moves them forward 13mm, normally a benefit to most riders. The text below describes the generic information about our SUB mounts.

---

"SUB" mount stands for Stabilizer Under Bars, originally designed for raising the bars. These kits are designed for use with Oversize bars. "Bar reducers" are available as an option, to convert the kit to standard diameter bars, should that be desired. This concept allows more room for other equipment such as, Global Positioning Systems(GPS) or Enduro/Rally computers and yet still retain the quick access for adjusting the stabilizer. This is also good for the taller rider who wants his bars a little higher, as it raises the bar location approximately 11-25mm, depending on the model of bike. In some cases, you might consider a lower bend handlebar bend at the same time, unless you are trying to achieve a higher bar height along with your stabilizer installation. We can also help you with other handlebar choices to match your desired setup, as we have a full selection of handlebars to choose from on this website. The SUB mounts are only available on certain models based on the physical limitations of mounting in this area. Each SUB mount comes complete with all necessary parts, hardware and "Step by Step" pictured instructions. If you have any questions, feel free to call or email us. The Photo attached here may be a generic photo to show you the basic components in the kit, but may not be showing the exact kit for your specific bike.